Scrape
Smears an image along an angle defined by the Rotation parameter. The Scrape effect
starts at the center point, and continues to the edge of the object.
1058
Chapter 19
Using Filters
This filter causes rasterization in 3D groups. For more information on rasterization, see
About Rasterization
.
Original image
Scrape applied
Parameters in the Inspector
Center:
Sets the position of the center of the scrape. Drag the Center onscreen control
to adjust its value in the Canvas.
Rotation:
Sets the angle of rotation of the scrape. Drag the outer handle of the onscreen
control to adjust the Rotation value in the Canvas.
Amount:
Sets the ramping of the number of pixels spread across the range of the scrape.
Values range from 0 (very gradual) to 200 (hard edge).
Mix:
Sets the percentage of the original image to be blended with the distorted image.
Publish OSC:
Publishes the filter’s onscreen controls in Final Cut Pro X. For more
information on creating content for use in Final Cut Pro, see
Creating Templates for
Final Cut Pro X
.
HUD Controls
The HUD contains the following controls: Rotation and Amount.