Sweep
Pivots the camera across a specified arc.
Parameters in the Inspector
Start:
A dial that sets the camera’s starting angle relative to its current orientation. A
nonzero value causes the camera to jump to this value at the start of the behavior.
1263
Chapter 21
3D Compositing
End:
A dial that sets the camera’s final angle relative to its Start parameter value.
Speed:
A pop-up menu that sets the type of interpolation used for the rotation. The value
can be set to Constant, Ease In, Ease Out, Ease Both, Accelerate, or Decelerate.
Axis:
A pop-up menu that sets the axis around which the sweep occurs. Value can be
set to Tilt X, Swivel Y, or Roll Z.
HUD Controls
The HUD contains the same controls as the Inspector.